Rockwell Automation 1203-USB USB Converter (Same as DRIVES-UM001) Out of synch with AB version. - Manual (Page 19)

Configuring the Converter 4-1
C
HAPTER
4
Configuring the Converter
Chapter 4 provides instructions and information for configuring the 1203-USB
converter.
4.1 Configuration Tools
The 1203-USB converter stores parameters and other information in its own
Non-Volatile Storage (NVS) memory. You must, therefore, access the converter to
view and edit its parameters. The following tools can be used to access the converter
parameters:
Important: The RS-485 serial port on MDI drives does not need to be configured
before using the converter. MDI communications are configured
automatically (19.2K baud and 8-N-1).
Topic Page
Configuration Tools 4-1
Using the DPI Class OIM 4-2
Using the MDI Class OIM 4-4
Using V*S Utilities 4-4
V*S Utilities Quick Start 4-5
Using Terminal Emulation Software 4-6
Resetting the Converter 4-8
Table 4.1 – Configuration Tools
Tool Refer to...
DPI Class OIM (20-OIM-*) Page 4-2
MDI Class OIM (33-OIM-*) Page 4-4
V*S Utilities Software (version 4.06 or higher) Page 4-4
Terminal emulation software Page 4-6