Rockwell Automation Drives and Motion Accelerator Toolkit Quick Start Summary - Manual (Page 2)

Rockwell Automation Publication IASIMP-QS022B-EN-P - April 2012
2 Drives and Motion Accelerator Toolkit Quick Start Summary
Quick Start Chapter Summary
Follow this path to complete your Drives and Motion
application.
Chapter 1 - Initial System Configuration Using the
DMAT Wizard
In this chapter you use the Rockwell Automation DMAT
Wizard to create an initial bill of materials, assemble a system
drawing set, and create an RSLogix™ 5000 project file with a
preconfigured controller, network, drives and initial system
program logic. In addition, you are introduced to several
Rockwell Automation system configuration tools that provide
assistance in sizing your motor/drive combinations for a variety
of load, transmission, and application types.
Chapter 2 - Bill of Materials Completion
In this chapter you use Rockwell Automation ProposalWorks™
software to complete the drives and motion system bill of
materials that the DMAT Wizard created.
Chapter 3 - System Layout and Wiring
In this chapter you edit the set of layout and wiring drawings
from the DMAT drawing library that the DMAT Wizard
created.
Chapter 4 - Logic Configuration
In this chapter you edit the preconfigured logic file that the
DMAT Wizard created for your specific application.
MOTOR
FIELD SIDE DRIVE
PROTECTION
POWERFLEX 4
AC DRIVE
MOTOR_01
USER PROTECTED
XXXVAC SUPPLY
MAINS DISCONNECT
PROTECTION
XXAMPS
FILTERED POWER
Chapter 3
System Layout and Wiring
Chapter 1
Initial System Configuration Using the DMAT Wizard
Chapter 2
Bill of Materials Completion
Chapter 4
Logic Configuration