Rockwell Automation Logix5000 Control Systems: Connect PowerFlex 70 Drives over EtherNet/IP Quick Start - Manual (Page 13)

Rockwell Automation Publication IASIMP-QS031A-EN-P - February 2012 13
Chapter
1
Prepare the PowerFlex 70 Drive Hardware
In this chapter, you learn how to complete the following tasks:
• Mount and wire power to a 20A-B4P2A0AYNNNC0 drive.
• Configure EtherNet/IP communication for the drive.
Before You Begin
You must complete these tasks before using this chapter:
• The tasks described in Before Using This Publication on page 5 , including:
– Prepare the Logix5000 control system hardware
– Prepare the computer
– Configure the networks - The tasks described in this chapter require an
EtherNet/IP network.
– Create an RSLogix 5000 project
The example RSLogix 5000 project used in this chapter uses a
CompactLogix 5370 L3 controller.
What You Need
This table lists the products you need to complete the tasks described in this chapter.
Quantity Cat. No. Description
1 20A-B4P2A0AYNNNC0 PowerFlex 70 AC drive
1 20-COMM-E Communication adapter for use with the PowerFlex 70 drive
1 1585J-M8PBJM-2 RJ45 to RJ45 patchcord Ethernet cable