Rockwell Automation 8520-OM Offline Development System Software - Manual (Page 81)

7–7 Using ODS Communication Configuration
Publication MCD-5.1 -August 1999
To configure the information for the 1784-KTK1 module, select (A)
from the Driver Type menu. Figure 7.6 describes the menu flow
used to configure the KTK1 module.
Figure 7.6
Configuration Flow for the 1784ĆKTK1
Select the communications port that will be used for Data Highway Plus
communications.
Select the address of the driver card that will communicate over the
Data Highway Plus (PLC). This address must match the address selected
on the switch setting on the 1784ĆKT module. Address range is 10 binary
digits. Default value is 00001 10000.
Select the station address of the ODS terminal on the Data Highway Plus.
Address range is from 0 to 77 (octal). The default value is 77.
Select the station address of the logic controller on the Data Highway Plus.
Address range is from 0 to 77 (octal). The default is 02.
Select the type of connection used on the Data Highway Plus. Direct
indicates only a logc controller and the ODS terminal are connected.
Multidrop indicates more than one logic controller and ODS terminal are
connected. The default selection is Direct.
Select the device interrupt address of the 1784ĆKTK1 module (IRQ3, IRQ5,
Select the IMC rack address. The address range is 0 through 7.
Select the IMC group address. The address range is 0 through 7.
Select the delay time between Block Transfer read/write requests and Block
Transfer read requests to get the status from the last BLT. The delay time
range is 0 to 9999 milliseconds. The default value is 2500.
IRQ10, IRQ12). Chose an address that does not conflict with an already
installed card. The default selection is IRQ5.
1.
2.
3.
4.
5.
6.
7.
8.
9.
1784ĆKT Driver Type
Port Type Desired
Address of Driver Card
DH+ Station Address of Terminal
Connection Type Desired
Device Interrupt
DH+ Station Address
of Logic Controller
Handshake Delay
IMCĆ12x Rack Address
IMCĆ12x Group Address
The default value is 0. IMC 12x includes IMC-120, IMC-121,
IMC-123, and IMC-123CR.
The default value is 0. IMC 12x includes IMC-120, IMC-121,
IMC-123, and IMC-123CR.
Configuring the
1784-KTK1