Rockwell Automation 9399 A.I. SERIES INSTALLATION GUIDE - Manual (Page 39)

Installation Guide
2-12
Shortcut for Moving Activation Files
You can move the activation files without using the SETUP disk.
Note Make certain that your Master Disk is not write protected before using it to move your
software. (See the note on page 1-4 if you need help distinguishing a write protected
disk.)
Note In this example, we use drive A: for the floppy disk drive, and C: for the hard drive.
This is a common configuration, but yours may be different. If it is, substitute the
appropriate drive letters for your system.
To move the activation files from one computer to another without the Setup disk:
1. Make sure you are at a DOS prompt. If you are using Windows either exit or shell
to DOS or open a DOS window.
2. Insert the Master Disk in drive A: on the primary system (substitute drive letters
appropriate for your system) and type:
•
A: [Enter]
•
EVMOVE C A [Enter]
•
Y [Enter] (to confirm the move)
3. Take the Master Disk to the secondary system, insert it in drive A: and type:
•
A: [Enter]
•
EVMOVE A C [Enter]
•
Y [Enter] (to confirm the move)
Note You can run EvMove without the Master disk if you have copied the file EVMOVE.EXE
from the Master disk onto your hard disk.