Rockwell Automation 9399 A.I. SERIES INSTALLATION GUIDE - Manual (Page 36)

Copy Protection
2-9
Moving Activation Files
If you decide to move your A.I. Series software to another computer, you need to
remove the activation files from the computer on which the software is installed. The
Setup program provides a utility for moving Activation files. The Move function will
not install any of the program or data files associated with the A.I. Series software. If
you wish to move both the Activation files and the program files to the hard drive, use
the Setup program's Install routine instead. The Move utility allows you to copy
Activation files to and from any local or network drive.
You can run the Move utility from the Master disk or directly from a hard drive. Copy
the file EVMOVE.EXE from the Master disk onto your hard disk. You can then run
EVMOVE in basically the same way as described on the following pages, except
without the Master disk.
Note To move activation files to a network drive, you must have read, write, and creation
privileges for the root directory of that network drive.
The Move utility, EvMove, can run in DOS or Windows mode depending on your
operating system.
If you run EvMove from… Then…
DOS the DOS flavor of the Move utility will run.
Windows the Windows flavor of the Move utility will run.
a DOS box under Windows the DOS flavor of the Move utility will run.
a DOS box under Windows 95 or
Windows NT the Windows flavor of the Move utility will run.
You can also shortcut the Move utility in Setup by typing commands directly at the
DOS prompt. Each of these options is described in the following sections.