Rockwell Automation 2097-PGMR Memory Module Programmer Quick Start - Manual (Page 4)

4 Bulletin 2097 Memory Module Programmer
Publication 2097-QS001D-EN-P - November 2011
Power Supplies
The memory module programmer ships with 4 (1.5V mono-cells) batteries preinstalled, and is
ready for use. It can also be operated with an external power supply.
Batteries Operation
For battery operation, you need 4 mono-cell (D size) with 1.5V each. To access the battery
compartment, open the housing on the bottom of memory module programmer.
Battery Replacement
1. Remove the five screws and base plate.
2. Insert the batteries following correct
polarity.
3. Replace the base plate and secure with the
five screws.
Pb
ATTENTION: This product contains a sealed lead acid battery which may need to be
replaced during the life of the product.
At the end of its life, the battery contained in this product should be collected
separately from any unsorted municipal waste. The ‘Pb’ symbol indicates the presence
of lead.
The collection and recycling of batteries helps protect the environment and
contributes to the conservation of natural resources as valuable materials are
recovered.