Rockwell Automation 61C351 2-In/2-Out 4-20 mA Analog Rail Module - Manual (Page 40)

5Ć6
Module
Faceplate
3 screws
on top
3 screws on bottom
3 screws
on the right
2
screws
on left
Figure 5.1 Ć Disassembling the Module to Replace the 32mA Fuse
e) Place the metal enclosure side of the leftĆhand piece
on a clean surface. Note the position of the fuses from
the drawing in figure 5.2. As shown on the drawing,
the topfuse (labeled F1) is for channel 2 and the
bottom fuse (labeled F2) is for channel 3. The fuses
are held in place by spring clips. Remove the blown
fuse(s) carefully and discard. Replace the fuse(s) with
a new fuse.