Rockwell Automation AutoMax Prog Exec V4.2 and Dist. Power System Drive Software Install - Manual (Page 23)

9Ć1
9.0 INSTALLING ADDITIONAL
5ĆUSER LICENSES FOR
SHAREDĆUSER DPS
SOFTWARE
The number of users having access to the sharedĆuser DPS
software on a network can be increased by installing as many 5Ćuser
licenses (M/N 57C650) as required. The sharedĆuser Executive and
DPS software must already exist on the network.
IMPORTANT: The installation procedure for M/N 57C650 below is
used when you have purchased M/N 57C650 to add additional
users to an existing sharedĆuser DPS installation. If you are installing
M/N 57C650 for the first time to allow up to 5 users to run the
software, you must use the procedure described in chapter 8
instead.
Use the following procedure to add 5 additional DPS users to the
sharedĆuser Executive.
Step 1.
Insert the DPS software disk labeled Add Users" in
floppy drive A: or B:.
Type A:\ADDUSER or B:\ADDUSER
You will be prompted for the network server directory where the
Executive software is located.
Step 2.
Enter the directory path, e.g.,
:\\.
The current number of users will be displayed, and you will be
prompted for the new user limit.
Step 3.
Enter the old number of users plus 5 (five maximum with
each license).
The new total number of users will be displayed.