Rockwell Automation AutoMax Prog Exec V4.2 and Dist. Power System Drive Software Install - Manual (Page 21)

8Ć1
8.0 INSTALLING THE
OPTIONAL SHAREDĆUSER
DPS SOFTWARE
This chapter describes how to install the sharedĆuser version of the
DPS software. The sharedĆuser DPS software allows up to five users
to simultaneously run the Executive software with DPS software
options. The software is installed on the network server only.
Prerequisites for Installation
1. You must install the sharedĆuser Executive software before
installing the sharedĆuser DPS software.
2. You must install the separatelyĆpurchased singleĆuser DPS
software option(s) required for your application. Any number or
combination of DPS software options is permitted.
3. IMPORTANT: The installation procedure for M/N 57C650 below
is used when you initially install the sharedĆuser DPS software. If
you have purchased M/N 57C650 for the purpose of adding
additional users to an existing sharedĆuser DPS installation, you
must use the procedure described in chapter 9.
During the installation procedure, the following subdirectories will be
created on the network hard disk if they do not already exist:
:\RPE\
:\RPE\\TEMP
:\AMXWORK
Install the sharedĆuser DPS software on the network server following
the directions below. This procedure must be performed before
installing the sharedĆuser DPS software on each network node.
Step 1.
To begin installing the DPS software, insert the disk
labeled 1" in floppy drive A: or B:.
Click Start, then click Run, and then type:
ą:\INSTALL.EXE
where:
ą is the floppy drive in which you have placed
ąthe disk.