Rockwell Automation 1794-AENTR_AENTRXT FLEX I/O Dual Port EtherNet/IP Adapter Modules - Manual (Page 61)

53 Publication 1794-UM066A-EN-P - February 2012
Appendix
B
Specifications
Overview This appendix contains general and environmental specifications and
certifications for the FLEX I/O Dual Port EtherNet/IP Adapter Modules.
General Specifications – 1794-AENTR, 1794-AENTRXT
Specification 1794-AENTR 1794-AENTRXT
I/O capacity 8 modules
Power supply To comply with the CE Low Voltage Directive (LVD), this equipment must be
powered from a source compliant with the following:
Safety Extra Low Voltage (SELV) or Protected Extra Low Voltage (PELV).
Input voltage rating,
nom 24V DC
Input voltage range 19.2…31.2V DC (includes 5% AC ripple)
Inrush current 18 A for 2 ms
Communication rate 10/100 Mbps
Indicators Module status – red/green
Network status – red/green
Link 1 – yellow/green
Link 2 – yellow/green
FlexBus output, max 5.0V DC
640 mA
Isolation voltage 50V (continuous), Basic Insulation Type
Tested @ 1000V AC for 60 s, power to FlexBus to EtherNet
Power consumption,
max 500 mA,
400 mA @ 24V DC
Power dissipation,
max 7.1 W @ 19.2V DC
Thermal dissipation 24.2 BTU/hr @ 19.2V DC
Ethernet connector RJ45 Cat. 5
Enclosure type rating None (open-style)
Wire size Power conductors:
0.33…3.31 mm
2 (22…12 AWG) stranded copper wire rated @ 75 °C
(167 °F) or greater, 1.2 mm (3/64 in.) insulation max
Wiring category
(1)
(1) Use this Conductor Category information for planning conductor routing. Refer to Industrial Automation Wiring
and Grounding Guidelines, publication
1770-4.1 .
1 – on power ports
2 – on communication ports
North American temp
code T5 T4A
IEC temp code T5 T4
Terminal screw torque 0.8 Nm (7 lb-in.)
Weight, approx. 227 g (8.01 oz)
Dimensions, HxWxD,
approx. 87.4 x 94 x 92 mm
(3.44 x 3.7 x 3.6 in.)