Rockwell Automation 2711P-RDT12H High-bright Display Module - Manual (Page 23)

High-bright Display Modules 23
Publication 2711P-IN026E-EN-P - September 2008
Start-up Information Messages
Start-up information messages display in a specific sequence on the terminal during
startup and typically display for a few seconds. These messages do not require that
you perform any action.
Message # Message Description
37 Video Initialized Configures and initializes the graphics video system.
30 Watchdog Test Tests the watchdog circuitry to verify system integrity.
1 RAM Test Tests the RAM memory.
31 Stuck Key Checks the integrity of the function key hardware.
31.5 Stuck Touch Checks the integrity of the touch screen hardware.
32 Battery Test Checks the integrity of the battery hardware.
2.5 Registry Search Locates and loads the most recent, valid registry. Multiple copies of
the registry are maintained. If power is lost during a registry update, a
valid registry is available the next time power is applied to the
terminal.
2 Image Search Checks for a new OS firmware upgrade on the external CompactFlash
card and the serial port.
50 External CF Transfers a new OS firmware upgrade from the external
CompactFlash card to the terminal. Message may display for several
minutes.
23 Internal CF Programs the OS firmware just downloaded into the internal flash
memory. Message may display for several minutes.
24 CRC Check Checks the integrity of the OS firmware.
28 Starting System Launches the operating system (OS).
29 System Check ### Internal file system integrity check (### is percent progress indicator).
29.1 System Check Internal file system integrity check disabled. Contact technical
support.