Rockwell Automation 57C445 AutoMax PC Link Interface Module User Manual
Page 50
EĆ2
DAE Installation
The DAE executable is called RELICOMM.EXE. If you are using ScreenWare2
version 3.10, place this file in the directory \SW2\ANIMATE and rename it
DAE.EXE. ScreenWare2 can then access and load DAE from ScreenWare2's
master menu.
Use the following command line structure to access the PC Link module:
DAE
where:
file
(required)
The file argument specifies the application path and file that has been
created using the ScreenWare2 logic editor. The application file always
has an .APP extension. The file extension does not have to be included in
the argument on the command line.
drop
(optional)
The drop argument specifies the starting drop number that you want the
ScreenWare2 operator station to adopt on the AutoMax network. If there
is a conflict with an existing drop on the network, an error message will
be generated and DAE will exit.
Note that the drop must be specified if the
ScreenWare2 application is to write to the network. If the drop is not
specified, ScreenWare2 can only read from the AutoMax network.
depth (required if drop is specified; otherwise optional) The depth argument
specifies the number of drops (starting at the drop specified) that you
want the ScreenWare2 operator station to adopt on the AutoMax network.
If there is a conflict with an existing drop on the network, an error
message will be generated and DAE will exit.
address (optional)
The address is a hexadecimal argument which specifies the starting
address of the dual port memory with reference to the host memory.
This must coincide with the address specified in the command line of
the PC Link software loader program. If the address is omitted, the DAE
assumes that the PC Link module dual port memory resides at
segment D0000 (default address).
For example,
DAE ..\SW2FILES\RELI.APP Ćd10 Ćh4 ĆaD000