2 module replacement – Rockwell Automation 57C445 AutoMax PC Link Interface Module User Manual

Page 22

3Ć10

3.2

Module Replacement

To replace a module that is connected using a tee adapter, use the

following procedure:
Step 1.

Stop any application tasks that may be running.

Step 2.

Disconnect the tee adapter from the PC Link module.

Step 3.

Turn your computer off. Disconnect the power cord.

Step 4.

Remove the cover on your computer.

Step 5.

Use a screwdriver to remove the screw from the bracket

holding the PC Link module and remove the module.

Step 6.

Take the new module out of its shipping container. Take it

out of the antiĆstatic bag, being careful not to touch the

connectors on the bottom of the board or any surface of

the board.

Step 7.

Set the DIP switches to match the port address set on the

old module.

Step 8.

Insert the module into your computer. Make sure the

goldĆstriped bottom edge of the board sits firmly in the

expansion slot groove, and that the bracket of the board is

seated properly. Secure the board with the bracket screw.

Step 9.

Replace the cover on your computer.

Step 10. Turn on power to your computer.
Step 11. ReĆconnect the tee adapter to the module.