Rockwell Automation 1786-TPST2T ControlNet IP67 Tap and Cable Assembly Kit Installation Instructions User Manual
Installation instructions, What’s in this document
Publication 1786-IN017B-EN-P - May 2004
Installation Instructions
ControlNet IP67 Tap and Cable Assembly Kit
Installation Instructions
Cat. No.1786-TCT2BD1, -TPST2T, -TPRT2T
What’s in This Document
This document describes how to install the ControlNet IP67 Tap and Cable Assembly Kit.
The kit is available in three versions, as shown in the table below. All kits are identical, except
for the 1-meter drop cable.
The kit is made up of a tap body and a 1-meter drop cable with overmolded connectors. The
drop cable has a TNC connector at the tap body end and either a BNC or TNC connector at
the ControlNet node end (depending on the version of the kit you order). The tap and cable
are rated to IP67 when mated to a sealed connector, which means they are water-tight.
for this version of the drop able
order this kit
TNC to Straight BNC (TNC at tap body; BNC at node
end)
1786-TCT2BD1
TNC to Straight TNC (TNC at tap body; TNC at node
end)
1786-TPST2T
TNC to Right-angle TNC (TNC at tap body; TNC at node
end)
1786-TPRT2T