Rockwell Automation 1785-L20C_L40C QUICK START CONTROLNET PLC-5 - Manual (Page 7)

Publication 1785-10.6 – August 1997
Chapter 1
Introduction 1–1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Identify the Processor’s Front Panel Components 1–1 . . . . . . . . . . . . . .
Check Your Components 1–2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 2
What You’ll Be Doing in This Chapter 2–1 . . . . . . . . . . . . . . . . . . . . . .
Configure the I/O Chassis 2–2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ground the I/O Chassis 2–3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Install the Power Supply 2–4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Install the PLC-5 Processor 2–5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Powerup the System 2–6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Install the I/O Modules 2–6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Connect the Personal Computer to the PLC-5 Processor 2–6 . . . . . . . .
Chapter 3
Install the Software and Set Up the Programming System 3–1 . . . . . . . .
Start the Programming Software 3–1 . . . . . . . . . . . . . . . . . . . . . . . . . .
Power Up the System 3–1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 4
Using This Chapter 4–1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Using the General Status Indicators 4–1 . . . . . . . . . . . . . . . . . . . . . . .
Using the ControlNet Status Indicators 4–3 . . . . . . . . . . . . . . . . . . . . .
Using the DH+/RIO Status Indicators 4–5 . . . . . . . . . . . . . . . . . . . . . . .
Monitoring ControlNet Configuration and Status 4–6 . . . . . . . . . . . . . . .
Appendix A
Table of Contents
Before You Begin
Set Up the Hardware
Set Up the Software
Troubleshoot the Processor
System
Processor Specifications