Rockwell Automation 1785-L20C_L40C QUICK START CONTROLNET PLC-5 - Manual (Page 17)

2–5 Set Up the Hardware
Publication 1785-10.7 – October 1997
Install the PLC-5 Processor
Card Guides
Lift Ejector Tab
20610–M
Define the DH+ Station Address of Channel 1A
by setting switch assembly SW-1 on the back of
the processor. (See the side of the processor if
you want to use another address.)
side view of processor
side view
1 2 3 4 5 6 7
Battery Connector
Battery Cover
Battery
1
4
5
PLC-5/20
Processor
Locking Bar
2 Specify the serial port configuration for
channel 0.
Front of
Processor
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
Front of
Processor
bottom view of PLC-5/20C processor
bottom view of PLC-5/40C and -5/80C processor
side view
OFF
More
For more information, see the ControlNet PLC-5 Programmable
Controllers User Manual, publication number 1785-6.5.14.
More
For detailed information about handling and disposing of the battery
as well as other important guidelines, see publication AG-5.4.
up
230 Kbaud
down
57.6 Kbaud For series E and later processors:
use this switch to select baud rate
For series D and earlier processors:
this switch is always off
Install the processor module.
To install the battery, slide the battery-side
connector into the processor-side connector
until you hear them snap together, and attach
the battery cover.
3 Set the ControlNet network addresses by
using the two 10-digit rotary switches on
top of the module.
90
ControlNet PLC-5 processor’s NET address = 1
10
00
80 70
60
50
40
20 30
9
1
0
8 7
6
5
4
2 3