Rockwell Automation 1785-ENET PLC-5 Ethernet Interface Module Installation Instructions - Manual (Page 45)

PLC-5 Ethernet Interface Module 45
Publication 1785-IN019B-EN-P - January 2007
Controller Fault Codes
Specifications
Fault Code Description
91 Module undefined message type.
92 Module requesting undefined pool.
93 Module illegal maximum pool size.
94 Module illegal ASCII message.
95 Module reported fault, in which a bad program causes memory corrupt, or, of a hardware failure.
96 Module not physically connected to the controller.
97 Module requested a pool size that is too small for PCC command (occurs when cycling power).
98 Module first/last 16 bytes RAM test failed.
99 Module-to-controller data transfer faulted.
100 Controller-to-module transfer failed.
101 Module end-of-scan transfer failed.
102 The file number specified for raw data transfer through the module is an illegal value.
103 The element number specified for raw data transfer through the module is an illegal value.
104 The size of the transfer requested through the module is an illegal size.
105 The offset into the raw transfer segment of the module is an illegal value.
106 Module transfer protection violation; for PLC-5/26, PLC-5/46, and PLC-5/86 controllers only.
Ethernet Interface Module - 1785-ENET
Attribute Value
Backplane Current 1.0 A @ 5V dc
Power Dissipation 5 W
Heat Dissipation 17.06 BTU/hr
IEC Temp Code T5
North American Temp Code T5
Isolation Voltage 50V, Basic Insulation Type
Tested at 500V ac for 60 s, Communications to system
Wire Type Ethernet: 802.3 compliant shielded or unshielded twisted pair
Wiring Category (1)
(1) Use this Conductor Category information for planning conductor routing. Refer to Industrial Automation Wiring and
Grounding Guidelines, publication 1770-4.1.
2 - on communications ports
Communication Ethernet (TCP/IP protocol 8-pin RJ45 port)
Weight, Approx. 0.77 kg (1.7 lb)
Dimensions (HxWxD), Approx. 273.05 x 31.75 x 146.05 mm (10.75 x 1.25 x 5.75 in.)