Rockwell Automation 1746-XXXX SLC 500 4-Channel Analog I/O Modules Installation Instructions - Manual (Page 16)

16 SLC™ 500 4-Channel Analog I/O Modules
Publication 1746-IN008C-EN-P - May 2004
Labeling and Installing the Terminal Block
The terminal block has a write-on label. Labeling the terminal block will help
ensure that it is installed on the correct module.
When installing the analog module in a chassis, it is not necessary to remove the
terminal block from the module. However, if the terminal block is removed, use the
write–on label located on the side of the terminal block to identify the module
location and type.
Once you have wired your analog module and properly labeled the terminal block,
install the terminal block on the analog module. To install the terminal block:
1. Align the terminal block with the receptacle.
2. Insert the terminal block and press firmly at the top and bottom until it is
properly secured.
To remove the terminal block, grasp it on the top and bottom and pull outward and
down.
TIP
The black dot on the terminal block label indicates the
position of terminal 0.
SLOT ____ RACK ____
MODULE _____
Terminal Block
@JO$&/QQE @JO$&/QQE ". ".