Rockwell Automation 1756-ENET/B ControlLogix Ethernet Communication Interface Module User Manual - Manual (Page 66)

Publication 1756-UM051B-EN-P - November 2000
6-2 Analog I/O with Direct Connection
Set Up the Hardware Change the system configuration of the previous chapter to that
shown below, adding an analog output module to the remote chassis
in slot 3. For this example, we used a 1756-OF8 analog output
module.
•
Note that in the example application, the Logix5550 controller,
I/O modules, and the 1756-ENET/B modules are in the slots
shown above.
•
Verify that the IP addresses for the 1756-ENET/B modules and
personal computer are correct.
•
Verify that all wiring and cabling is properly connected.
•
Make sure you have your communication driver (e.g., TCP-1)
configured in RSLinx as described in Appendix C.
Logix5550 1756-ENET/B 1756-ENET/B
Data
Slot 0 1 Slot 0 1 2 3
1756-IB16I
Digital Input
1756-OB16I
Digital Output
Controller
Switch
Programming
130.130.130.1
130.130.130.2 130.130.130.3
Terminal
Local
Chassis Remote
Chassis
1756-OF8
Analog Output