Rockwell Automation 1784-KT2/C INST.DATA COMM.INTERFACE MOD. - Manual (Page 20)

Communication Interface Module
Cat. No. 1784-KT2/C
Installation Data
20
Running the Diagnostic Program
When you have completed the start–up procedures, the following screen
appears:
You must now specify which 1784–KT2 module you want to test. To do
this, follow the steps below:
1. Press [F3]. The number of each slot containing a 1784–KT2 is
displayed.
2. Specify the slot number of the 1784–KT2 you want to test by moving
the cursor to the desired slot number and pressing [ENTER]. You can
press [F3] to select a new module whenever [F3] appears on the
screen.
The following sections describe each of the above diagnostic options.