Rockwell Automation 1784-KT2/C INST.DATA COMM.INTERFACE MOD. - Manual (Page 19)

Communication Interface Module
Cat. No. 1784-KT2/C
Installation Data
19
When the prompt appears, type:
cd c:\kt2diag [ENTER)
Important: The diagnostic program adds new test results to results
already existing in the output file. If you want to delete test results already
existing in the output file, wait for the prompt to appear and type:
del kt2out.txt [ENTER]
Do this before you proceed to step 3.
3. When the prompt appears, type:
kt2diag [ENTER]
You see the following message:
WARNING: Serious damage will occur if 1784–KT2 is
connected to a network. Press any key to acknowledge:
Make sure your 1784–KT2 is not connected to your network
and press any key to continue.
4. Again you are asked if you want to continue. If you have followed
the precautions to guard against network damage explained earlier in
this section, type y. If you have not yet read this information, type n
to exit the diagnostic program. You must read this information before
going any further.
5. An Allen-Bradley copyright message appears on your screen. Press
any key to continue.
The Allen-Bradley 1784–KT2 Diagnostic Program menu appears on your
screen. You are now ready to run the diagnostic program.