Rockwell Automation 1747-DSN DISTRIBUTED I/O SCANNER - Manual (Page 5)

A–B
P
Preface
Read this chapter to familiarize yourself with the rest of the manual. It
provides information concerning the:
•
contents of this manual
•
intended audience
•
conventions used
•
warnings and cautions
This manual describes how the Distributed I/O (DIO) Scanner, Catalog
Number 1747–DSN, is used in the Distributed I/O System. It will help you:
•
understand the DIO system and its components
•
select appropriate DIO system components for your application
•
install, program, start up, and operate your DIO Scanner
This manual provides specific information regarding scanner installation and
operation. In addition, it offers general information on the other DIO system
components.
The following table identifies the chapters, titles and contents.
Chapter Title Purpose
P Preface
Familiarizes you with the rest of the
manual.
1 Introduction Provides an overview of the DIO system.
2 Wiring and Installation
Describes how to install and wire the
DIO Scanner.
3
Configuration and
Programming
Describes how to program the SLC
processor that controls the DIO Scanner
and DIO system.
4
Start Up, Operation, and
Troubleshooting
Provides LED status information,
troubleshooting suggestions and error
codes.
5 Specifications
Contains DIO Scanner and DIO System
specifications.
A Appendix A Contains I/O Block Dip switch settings.
Using This Manual
Purpose of this Manual
Contents of this Manual