Rockwell Automation 1785-KA5P/B DHP COMM. ADAPATER MOD. - Manual (Page 16)

Installing the 1785ĆKA5
Communication Adapter Module
Chapter 2
2-5
If you are not using one of these two network configurations, do not use
the auto routing feature.
If you: Then:
do not plan to use the auto routing feature skip to the next section, How to Enable or
Disable the Module for Auto Routing to
learn how to disable the auto routing
feature
plan to use the auto routing feature continue with this section to determine if
you can use the auto routing feature in
your network
ATTENTION: Do not use auto routing in a network that
includes any of the following components:
1785-KE module
6008-LTV module
1785-KA module
1785-KA3 module
1775-S5 module
1784-KT card
1784-KTX card
1784-KTXD card
Module and system faults occur when you use auto routing in a system that
includes any of these network components. Be sure to disable the auto
routing feature when using these components.
How to Enable or Disable the Module for Auto Routing
Use switch assembly SW-2 to enable or disable the module for auto
routing.
To: Set switch 2 to
enable auto routing 1
disable auto routing 0
Important: Switch 1 of SW-2 is reserved. Always set this switch to (0).