Rockwell Automation 1794-L34 FlexLogix Controller System User Manual - Manual (Page 13)

Publication 1794-UM001G-EN-P - January 2007
Where to Start 13
Install Hardware To install a FlexLogix controller, follow these steps:
See:
• FlexLogix Controller Installation
Installation Step
o
1.
Install a DIN rail
o
2.
Use DIN rail locks that came with your controller
o 3.
Mount an appropriate power supply on the DIN rail
o 4.
Install the battery in the controller
See 8 “Maintain the Battery.“
o
5.
Install the communication cards in the controller
See Chapter 3 “Communicate over Networks”
o
6.
Install the controller on the DIN rail
o
7.
Install the extended-local adapter (optional)
o 8.
Make serial connections
See Chapter 2 “Directly Connect to the Controller via the Serial Port “
o
9.
Load controller firmware