Rockwell Automation 1794-L34 FlexLogix Controller System User Manual - Manual (Page 100)

Publication 1794-UM001G-EN-P - January 2007
100 Maintain the Battery
3. Remove the old battery.
4. Install a new 1756-BA1 battery.
5. Attach the battery label:
a. Write on the battery label the date you install the battery.
b. Attach the label to the inside of the battery compartment.
6. On the front of the controller, is the BATTERY LED off?
7. Dispose the old battery according to state and local regulations.
ATTENTION
Only install a 1756-BA1 battery. If you install a different
battery, you may damage the controller.
If: Then:
Yes Go to the next step.
No A. Check that the battery is correctly connected to the controller.
B. If the BATTERY LED remains on, install another 1756-BA1 battery.
C. If the BATTERY LED remains on after you complete Step B., contact your
Rockwell Automation representative or local distributor.
ATTENTION
Do not incinerate or dispose lithium batteries in general
trash collection. They may explode or rupture violently.
Follow state and local regulations for disposal of these
materials. You are legally responsible for hazards
created while your battery is being disposed.