Rockwell Automation 1608P ProDySC User Manual, 100/110 A - Manual (Page 7)

Rockwell Automation Publication 1608P-UM002A-EN-P - July 2013 7
Chapter
2
Installation
Installation Check List Before proceeding, please take a few minutes to review the necessary steps to
install your ProDySC.
• All packing materials and restraints have been removed.
• The ProDySC is placed in its installed location.
• All conduits and cables are properly routed to the ProDySC.
• All power cables are properly terminated.
• A ground conductor is properly installed and terminated.
• If neutral connection is required that it is properly terminated on the
ProDySC.
• The area around the installed ProDySC is clean and dust-free.
• Adequate work space exists around the ProDySC.
• Adequate lighting is provided around the ProDySC.
• Operational checks have been reviewed and completed.
Inspecting and Unpacking • Lift only at the base with a fork truck or pallet jack
• Carefully inspect the outer packaging for evidence of damage during
transit. Do not install a damaged cabinet. Report any damage to the carrier
and contact your local sales or service immediately.
• Check the ProDySC label for correct model number with the packaging
list to ensure you have received the correct voltage, current, and wiring
configurations.
• After removing the packaging material, inspect the contents for any
evidence of physical damage, and compare each item with the Bill of
Lading. If damage has occurred or shortages are evident contact your
carrier immediately.
Location (Environment) The ProDySC must be installed in a protected environment. The location must
provide adequate airflow around the ProDySC in an atmosphere free from
excessive dust, corrosive fumes, or conductive contaminants. Do not operate the
ProDySC in an environment where the ambient temperature or humidity is
beyond the specified limits given in this manual.