Rockwell Automation 1608P ProDySC User Manual, 100/110 A - Manual (Page 26)

26 Rockwell Automation Publication 1608P-UM002A-EN-P - July 2013
Chapter 5 Display Screen
System Event Detail
The "System Event Detail" screen is displayed when a specific system event is
selected by pressing on the "SELECT" button on the "SYSTEM EVENT LOG"
screen (See
Figure 21 on page 25 ). It provides detailed information that was
recorded during the event (See Figure 22 ).
Figure 22 - System Event Detail
Table 8 - System Event Detail
Description Function
Time/Duration
Time: Date and start time of the system event
Duration: The amount of time the event lasted.
Type
Event ID: Unique ID within the list (0-39) to identify the event.
Code: Abbreviation of the event followed by a numeric event code in parentheses. (For a
list of codes and abbreviations Refer to
System Event Table on page 32
Severity: Severity of the event
Description: Name of the event Refer to
System Event Table on page 32
Component
Location: The location in the system where the event originated (i.e. Phase A, Phase B,
Phase C, etc.).
Area: The specific area within the location where the event originated (i.e. Inverter, etc.).
Reading: In some cases, the system will record a relevant data value during the event i.e.
For an “Inverter Over-current Fault,” the component “reading” is the current value that
caused the event. If a data value is not appropriate for the event type, “N.A.” is displayed.