Rockwell Automation 1500 Modular Protection System Conversion Kit (GE Multilin to Bulletin 825 Plus) - Manual (Page 17)

1500-IN059C-EN-E – June 2013
Installation 4-
Removing Low Voltage Door
It is recommended to remove the low voltage doors to
facilitate cutting the mounting hole for 825 Plus. The hole
can be cut without removing the door if proper tools are used
and blankets, drop sheets or tarps are used to prevent drill
and saw chips from entering the controller.
Failure to check for clearance can result in damage to equip-
ment and/or personal injury.
1. Remove all door-mounted devices. Note wire numbers and locations. It
is recommended to create a sketch of the component layout and associ-
ated wiring locations. (Figures 4.3)
2. Use nut driver to remove nut on grounding stud. This will facilitate
removal of all wiring from the door.
3. Cut all remaining wire ties connecting wiring to the LV door.
4. Remove the low voltage door hinge pins. Caution must be taken when
removing the door. It is recommended that two people remove the door
– one person to hold the door and a second person to remove the hinge
pins. (Figure 4.4)
Ensure sufficient personnel are present to safely remove the
low voltage door. Failure to do so may result in personal
injury and/or damage to the equipment.
Figure 4.4
Figure 4.
ATTENTION
ATTENTION
IMPORTANT