Rockwell Automation 1494C-xxx - Series 2 Cable Operated Disconnect Switch Kit and Acessories (600A) - Manual

Table of Contents Page
Quick Installation Guide
- Disconnect Switch Installation
2,3
- Disconnect Handle Installation 3
- Cable Mechanism Installation 4
- Connecting Rod Adjustment Procedure 5
Conversion from Right Hand to Left Hand Operation 6
Enclosure Without Handle Cutout 7
- Locate Handle
- Drill Handle Holes
Door Catch Mounting Bracket Installation 8
Trailer Fuse Block Installation (600A) 9
Fuse Clip Installation (600A) 10
Bulletin 1494C Cable Operated Disconnect Switch Kit Components 11
Bulletin 1494C Cable Operated Disconnect Switch Kit Optional Accessory List
12
ATTENTION: The following procedures are critical to the proper operation of the disconnect handle and switch.
Failure to follow these steps can result in damage to the equipment and/or serious injury or death to the operator.
BULLETIN 1494C (600A) CABLE OPERATED
DISCONNECT SWITCH KIT INSTALLATION
INSTRUCTION SHEET
1 1026760
42052-190
OF
N/A
N/A
N/A
REVISION
AUTHORIZATION
DR.
CHKD.
APPD.
DATE
DATE
DATE
E - DOC
LOCATION: MILWAUKEE, WISCONSIN U.S.A.
B-vertical.ai
DWG.
SIZE
SHEET
B
1 2 3 4 5 6 7 8
A
B
C
D
E
F
G
H
REFERENCE
DIMENSIONS APPLY BEFORE
SURFACE TREATMENT
(DIMENSIONS IN INCHES)
TOLERANCES UNLESS
OTHERWISE SPECIFIED
.XX:
.XXX:
ANGLES:
42052
G. Ushakow 7-30-07
7-30-07
7-30-07
M. Jutz
J. Koziczkowski
ATTENTION: To prevent electrical shock, disconnect from power source before installing or servicing. Follow
NFPA 70E requirements. Install in suitable enclosure. Keep free from contaminants.
Bulletin 1494C Cable Operated Disconnect Switch Kit (600A)
Installation Instructions
(Cat 1494C- _ _ _ Series 2 : 600A)
42052-190-01 (1)
Printed in U.S.A.
THIS DRAWING IS THE PROPERTY OF
ROCKWELL AUTOMATION, INC.
OR ITS SUBSIDIARIES AND MAY NOT BE COPIED,
USED OR DISCLOSED FOR ANY PURPOSE
EXCEPT AS AUTHORIZED IN WRITING BY
ROCKWELL AUTOMATION, INC.
1 13