Rockwell Automation 1500 DeviceNet MV Controllers Installation Instructions - Manual (Page 25)

Chapter
7
1500-IN057C-EN-P – June 2013
System Commissioning and
Software Installation
The following optional items are suggested for IntelliCENTER and
DeviceNet MV controller installation and maintenance:

Hand tools—high-quality small-tip screwdriver, side-cutter,
needlenose pliers, wire stripper
 Terminating resistors equal to 121 ohms 1%, 1/4W, metal film –
part number 1485A-C2
 Five-terminal plug (part number PN 942154-05 with jack screws; PN
942153-05 without jack screws)
 Five-terminal receptacle (part number 22186-084-01)
 Ten foot (3 m) Class 1 round cable—for connecting devices to ports
(part number 1485C-P1-B50 for a 50 m spool)
 Short length of Class 1, 8 A round adapter cable with five-terminal
receptacle on each end
 Ten-foot (3 m) personal computer (PC) cable with five-terminal plug
on each end—part number 2100H-ICPC120
 Portable DeviceNet network for off-line testing and node
commissioning—required parts: small power supply (24 Vdc, 500
mA); DeviceNet cable; DeviceNet connectors; and terminating
resistors
 Digital multi-meter—Fluke 79 or equivalent
 ODVA DeviceNet monitor—order form available at http://
www.ab.com/intellicenter/instructions or contact product support
 DeviceView hand-held configurator—part number 2707-DNC
 Power supply for hand-held configurator—part number 2707-PS120
 Cable for hand-held configurator—part number 2707-NC13
 Laptop personal computer with the following software:
 RS Networx for DeviceNet
 RS Linx
 ControlFlash update software
 RS Logix 5 for PLC/5
 RS Logix 500 for SLC and MicroLogix
 RS Logix 5000 for ControlLogix
 IntelliCENTER software
DeviceNet Tool Box