Rockwell Automation 1608N MiniDySC User Manual, 12-50 Amp User Manual
Bulletin 1608n minidysc® dynamic sag corrector
Table of contents
Document Outline
- Important User Information
- Additional Resources
- Notes:
- Chapter 1
- Installation
- Installation Check List
- Inspecting and Unpacking
- Location (Environment)
- Mounting Considerations
- Rack Mount Considerations
- Heat Dissipation
- Mounting Dimensions
- L-N Versus L-L Configuration
- Completing Terminations
- Notes:
- Installation
- Chapter 2
- Operation
- Applying Power
- 1. Before applying power to the MiniDySC, ensure that all input/output wiring including grounding has been completed and that the wiring access cover is on and screwed down.
- 2. The load should be connected prior to performing system checks.
- 3. Apply power, note that the green “Normal” LED will be illuminated.
- 4. Verify that the output (load) voltage is present and within nominal rating.
- 5. During normal operation the green LED will remain on.
- Alarm LED Flash Sequence
- Communications
- Applying Power
- Operation
- Chapter 3
- Appendix A