Rockwell Automation 161 SERIES B FRN 2.001 - Manual (Page 7)

3
Getting Started
Receiving Your New Drive
It is your responsibility to thoroughly inspect the equipment before accepting shipment from the freight
company. Check the item(s) received against your purchase order. If any items are obviously damaged, do
not accept delivery until the freight agent notes the damage on the freight bill.
Unpacking
Remove all packing material, wedges, or braces from within and around the drive. Remove all packing material
from the heat sink. Leave the debris cover in place on the top of the drive.
If you find any concealed damage during unpacking, notify the freight agent. Also, leave the shipping container
intact and have the freight agent make a visual inspection of the equipment to verify damage.
Inspecting
After unpacking, check the item(s) nameplate catalog number against your purchase order. An explanation of
the catalog numbering system for the Bulletin 161 drive was provided in Figure 1.1 as an aide for nameplate
interpretation.
IMPORTANT: Before you install and start up your Bulletin 161, inspect for mechanical integrity. Look closely for
loose parts, wires and connections.
Nameplate Label
Figure 1.2 depicts a typical Bulletin 161 Nameplate Label.
Figure 1.2 Bulletin 161 Nameplate Label
161S-AA01NPK
SERIES
B
0.2 kW / 0.3 HP
FRN: 2.001
V: 200-230 3Ø V: 200-240 1Ш (3Ш)
A: 3.1(1.8)
Hz: 50/60
VA: 500
Allen-Bradley
A: 1.4
Motor
IP20
Hz: 0.5-360
POWER TERMINAL WIRE
S/N: Date: 9927 NE16452-2
MADE IN J APAN
82TT1362281161
O
I
N
P
U
T
U
T
P
U
T
Rating:
Use 75°C Cu Wire
2.1- 0.75m m 2 (14-18 AWG)
Torque 0.9 Nm (8 in.-lbs.)
Series
Letter
Catalog Number
Serial Number Enclosure Rating Firmware
Version