Rockwell Automation 20-750-PNET Profinet Single Port Option Module - Manual (Page 66)

66 Rockwell Automation Publication 750COM-UM006A-EN-P - January 2013
Chapter 8 Viewing the Option Module Web Pages
Configure E-mail
Notification Web Page The Configure E-mail Notification web page contains selections and data fields
for configuring the option module to automatically send e-mail messages to
desired addresses when selected types of events occur. To view this web page, click
the ‘Configure e-mail…’ link (highlighted in
Figure 8 ) in the navigation pane.
Figure 8 - Example of Configure E-mail Notification Web Page
By default, settings are not protected. After configuration, settings can be
protected by using
Device Parameter 20 - [Web Features] to set E-mail Cfg Bit 0
value to ‘0’ (Disabled). To change a protected configuration, it must first be
unprotected by setting the E-mail Cfg Bit 0 value back to ‘1’ (Enabled).
To configure e-mail notification, perform the following steps.
1. Click the desired ‘Send an e-mail message when…’ check boxes you want to
occur that will send e-mail notification.
If you only want e-mail notification when selected faults/alarms occur:
a. Click the respective fault and/or alarm radio buttons.
b. Click the ‘selected faults’ link and/or ‘selected alarms’ link.
c. Click the desired fault/alarm check boxes.
d. Click Save Changes.
e. Click the ‘Back to E-mail Configuration Page’ link.