Appendix b, Adapter parameters, Parameter list – Rockwell Automation 22-COMM-L LonWorks Adapter User Manual
Page 59: Parameter, Meters, refer to, Badapter parameters, Appendix
Appendix
B
Adapter Parameters
Appendix B presents information about the adapter parameters.
Topic
Page
Parameter List
Parameter
No. Name and Description
Details
01
[Send Service Pin]
Broadcasts a LON Service Pin Message from
the Neuron Chip. This provides the Neuron ID.
An alternate method for providing the Neuron ID
is enter the ID number manually. The Neuron ID
can be viewed using Parameter 04 - [Neuron
ID].
Default:
0 = Ready
Values:
0 = Ready
1 = Send
Type:
Read/Write
Reset Required
No
02
[Neuron State]
Displays the state of the Neuron Chip.
Default:
—
Values:
0 = appl_uncnfg
1 = cnfg_online
2 = unknown
3 = cnfg_offline
Type:
Read Only
03
[Reset Module]
No action if set to “0 = Ready.” Resets the
adapter if set to “1 = Reset Module.” Restores
the adapter to its factory default settings if set to
“2 = Set Defaults.” This parameter is a
command. It will be reset to “0 = Ready” after the
command has been performed.
Default:
0 = Ready
Values
0 = Ready
1 = Reset Module
2 = Set Defaults
Type:
Read/Write
Reset Required:
No
04
[Neuron ID]
Displays the Neuron Chip ID (6 bytes).
Default:
—
Values:
0 = Neuron Chip ID
Type: Read
Only
!
ATTENTION: Risk of injury or equipment damage exists. If the adapter is
transmitting I/O that controls the drive, the drive may fault when you reset the
adapter. Determine how your drive will respond before resetting a connected
adapter.