Rockwell Automation 22-COMM-L LonWorks Adapter - Manual (Page 25)

Configuring the Adapter 3-3
By default, when communications are disrupted (for example, a cable is
disconnected), the drive will remain in its current state (for example, a
running drive will continue to run) until Parameter 12 - [RcvHrtBeat
Time] has elapsed.
You can configure different responses to communications disruptions
using Parameter 06 - [Comm Flt Action] and Parameter 12 -
[RcvHrtBeat Time].
To change the Comm fault action
• Set the value of Parameter 06 - [Comm Flt Action] to the desired
response action.
Figure 3.1 Comm Fault Action Screen on PowerFlex 4-Class HIM (22-HIM-*)
Setting the Comm Fault Action
!
ATTENTION: Risk of injury or equipment damage exists. Parameter
06 - [Comm Flt Action] and Parameter 12 - [RcvHrtBeat Time] let
you determine the action of the adapter and connected drive if
communications are disrupted. Take precautions to ensure that the
setting of these parameters does not create a risk of injury or equipment
damage. When commissioning the drive, verify that your system
responds correctly to various situations (for example, a disconnected
cable).
Value Action
(1)
(1)
Actual action taken requires Parameter 12 - [RcvHrtBeat Time] to have a value
greater than “0.”
Description
0 Fault The drive is faulted and stopped. (Default)
1 Stop The drive is stopped, but not faulted.
2 Zero Data The drive is sent 0 for output data. This does not
command a stop.
3 Hold Last The drive continues in its present state.
4 Send Flt Cfg The drive is sent the data that you set in the fault
configuration parameters (Parameter 07 - [Flt Cfg
Logic] and Parameter 08 - [Flt Cfg Ref]).
Comm Flt Action
Parameter: # 006
Fault 0
VALUE LIMITS SEL !