Rockwell Automation 20B PowerFlex 700 Drive Components Replacement - Frame 8 - Manual (Page 54)

54 Rockwell Automation Publication 20B-IN024C-EN-P - June 2012
Chapter 3 Component Replacement Procedures
Current Transducer See Chapter 1 - Component Diagrams and Torque Specifications to locate the
component detailed in these instructions.
Remove Components
1. Read and follow the
Safety Precautions on page 12 and Important Initial
Steps on page 13 .
2. Label and disconnect the wire from the transducer.
3. Remove the two 17 mm bolts and one 11 mm nut that connect the U, V, or
W busbar to the output busbar.
4. Remove the bolt on the left end of the output busbar.
5. Use a hex wrench to remove the setscrew.
6. Remove the two screws that secure the transducer assembly to the
backplane (transducer and brackets).
Current Transducer
Transducer
Brackets
Output
Busbar
Setscrew