Yamato Scientific Vacuum controller Vacuum controller - Manual (Page 10)

8
Caution Caution Caution Caution
Handling of power code.
•
Do not entangle the power cord. This will cause overheating and possibly a fire.
•
Do not bend or twist the power cord, or apply excessive tension to it. This may cause a fire and
electrical shock.
•
Do not lay the power cord under a desk or chair, and do not allow it to be pinched in order to prevent it
from being damaged and to avoid a fire or electrical shock.
•
Keep the power cord away from any heating equipment such as a room heater. The cord's insulation
may melt and cause a fire or electrical shock.
•
If the power cord becomes damaged (wiring exposed, breakage, etc.), immediately turn off the power
at the rear of the product and shut off the main supply power. Then contact your nearest dealer for
replacement of the power cord. Leaving it may cause a fire or electrical shock.
•
Connect the power plug to the outlet which is supplied appropriate power and voltage. If the power cord
is connected the supply which is also connected to a aspirator or a vacuum pomp etc., with no
sufficient power and voltage, the product may not operate properly because the power would fall.
Piping
•
Vacuum hoses (outside diameter 12 x inside diameter 6mm) are required. These are not included in
accessories.
•
Refer to figure below in order to pipe. Stickers that indicate where to connect are attached at the rear.
Connect the pipes correctly in accordance with each indication of them.
The rear of the body
to condenser's
decompression
port of ROTARY
EVAPORATOR
to suction port of
ASPIRATOR
Vacuum Hose
Power code