Brother 4000CN - Manual (Page 127)

6-19
Message Meaning and Action
Replace Cyan
Toner (C) The cyan toner cartridge is empty.
Action:
Replace the cyan toner cartridge.
See 8.1.2 “Replacing the Toner Cartridges”
Reinsert Cyan
Toner (C) There is no cyan toner cartridge inserted in the printer or the
cartridge is improperly set.
Action:
Grip the levers at each end of the cyan toner cartridge with your
fingers, then push down firmly to rotate the levers forward to
install the cartridge.
See 8.1.2 “Replacing the Toner Cartridges”
Sys data cleared
Press Set
All system settings stored in the NV memory were deleted.
Action:
Follow the procedure below to reset the NV memory.
1 Press the
The printer settings may be deleted when you reset the NV
memory. Print the printer configuration list and the panel settings
list to confirm settings.
See 8.4.1 “Confirming Printer Configuration and Network
Settings”
See 5.3 “List of Menu Items”
No Paper in
All Tray There is no paper in any of the paper trays.
Action:
Load paper into the trays.
See 4.2.1 “Load Paper in the Paper Tray”
Push in
All Tray One of the trays is not properly inserted.
Action:
Push the all paper trays completely back into the printer.
Disk Full
Please Press Set The hard disk became full during electronic sorting and data
writing was halted.
Action:
Press the button.
It deletes print jobs from the printer. Print with one of the
following methods:
• Print fewer pages at a time.
• Deactivate the printer driver hard disk setting.
See 3.6 “Changing the Configuration for Options”
Check Paper
in MP Tray Paper is not properly loaded in the multi-purpose tray or is
different from that specified on the computer.
Action:
Make sure the paper is properly loaded into the multi-purpose
tray. If the computer settings are incorrect, cancel printing.
Check the following settings on your computer, reconfigure any
that are incorrect, and reprint.
• Is the correct paper tray specified?
• Is the correct paper size specified?
See 4.2.3 “Load Paper into the Multi-purpose Tray”
See 3.5.2 “Cancel Printing at the Control Panel”
Replace
Transfer Roll The transfer roll cartridge needs to be replaced.
Action:
Replace the transfer roll cartridge.
See 8.3.2 “Replacing the Transfer Roll Cartridge”