USG One-Directional Curvatura 3-D System - Manual (Page 8)

Note that some panels may be directional.
These panels will be marked on the back
and should be installed appropriately. Insert a C
urvatura
one-directional panel
into the first row by sliding it under the
stabilizer bars…
…and pulling or threading it all the way until
it butts up against the termination
cross tee.
If you’re using a full panel, cut off the
upturned flange on the one end. This
will make clearance for the hold-down
tabs on the termination cross tee. Use a screwdriver blade to bend in the
hold-down tab on the termination cross
tee and lock the panel into place.
Do not bend the hold-down tabs on the
main tees at this time.
Slide the next panel into the row…
…and press a panel joint splice onto
the joint. Repeat the process until reaching the
end of the row. Finish the row by cutting a panel to fit
into the last opening.
A. B. C.
D. E. F.
G. H. I.
Page 8 of 12
One-Directional C
urvatura
Installation Instructions
Step 4: Install Panels
Step 4:
Install Panels