USG One-Directional Curvatura 3-D System - Manual (Page 6)

Page 6 of 12
Tip: You can install additional stabilizer
bars in any row where extra support may
be needed.
Important…
Be careful to ensure that the row of
termination cross tees remains straight
and square throughout this phase of
the installation.
Extra care at this point will prevent
alignment issues later during installation.
I(a). I(b). J.
K. L.
1.
tee slot from the appropriate side. Without bending the tabs, position each
stabilizer bar slightly to the right or left
of the previous stabilizer bar…
…and attach each bar using a self
tapping screw at the pilot hole provided. Continue to install the flush-cut main
tees until all of the tees are installed
at one end.
Install temporary bracing to the ceiling
or nearby walls as necessary to assure
that the row of termination cross tees
remains straight, square, and rigid.
Step 2: Install a Row
of Flush Cut Main Tees
One-Directional C
urvatura
Installation Instructions
M.
Step 2:
Install a Row
of Flush-Cut
Main Tees
(continued)