Unisteer Ididit Keyless Ignition - Manual (Page 4)

3
There are a few different ways to install Your Key to Keyless system:
New Ignition Installations:
On a fresh build where you are installing all your wiring from
scratch, installation is as easy as wiring in a traditional Ignition
switch. Generous harness lengths allow for great freedom
of choice of module and Start button placement. Your Key to
Keyless Intelligent Push Button Start even lets you choose
how you would like to configure the systems operation. *See
Installation Diagrams
Custom, Hotrod or Vintage vehicles:
The Key to Keyless Intelligent Push Button Start adds an
elegant touch of technology to any vehicle. Our advanced and
versatile design using only professionally quality components
lets your Key to Keyless fit right into the most elite vehicles.
Straight forward easy to understand directions make replacing a
traditional Ignition key system an afternoon’s project.
Newer Vehicle: (with a locking steering column or security “chip” keys)
Rather then connecting every wire of a modern ignition switch,
the Key to Keyless Intelligent Push Button Start can be installed
as an “Ignition Switch Controller” on most newer vehicles.
This simple two wire installation allows your Key to Keyless
to control all ignition operations through the existing switch. It
completely eliminates any need to use a key to start your vehicle,
while leaving the existing locking steering column or manufacturer
security key systems in place. *See “Newer Vehicle Discussion” (pg
10) and “EZ Installation” (pg 15).
SyStEm OPERAtION:
Operating your KEy tO KEyLESS is designed to be absolutely effortless.
when you approach your vehicle, the system, upon reading your valid Key
FOB will pre-authorize your vehicles ignition system to start.
tO StARt:
Place your foot on the Brake, then depress of the Start Button and your
starter will begin to “crank” and continue until the button is released. The
Start Button LED will glow while your vehicle is running.
tO StOP yOUR ENGINE:
Place your foot on the Brake, Push and HOLD the Start Button for 2
seconds and your engine will shut off.