Unisteer Ididit Keyless Ignition User Manual
Page 19

tEStING tHE SyStEm:
Once you have completed your installation use the following instructions
to test the system.
Initial testing is done with the Key FOB in
manual mode. In manual mode
your proximity to the vehicle will not matter.
First test the Start button and Ignition system:
Exit the vehicle and wait 60 seconds for the system to Arm.
The LED in the Start button will go OFF, (* If Feature Select #4 is
selected the button will flash)
Depress the Unlock Button (
) on your Key FOB, this should authorize
the system.
Get in the vehicle and start your engine.
Assuming all went well, next test the automatic operation of the Key
FOBs:
* If you have more then one Key FOB, test them one at a time. Complete a
test of each Tag then proceed to the next
.
See:
manual & Automatic modes earlier in this manual
and find the instructions to put Key FOBs into Automatic mode.
Switch your first Key FOB into automatic mode.
walk 50+ feet away from your vehicle and set the tag down.
Walk back to your vehicle wait 60 seconds and confirm the Start Button
LED is flashing.
Enter and attempt to start the vehicle. It should not start.
Go back pick up your Key FOB and walk to the vehicle.
Now get in and Start your engine!
18