Unisteer Ididit Keyless Ignition - Manual (Page 18)

17
ImPORtANt: It is critical that your Start / Crank wire is ran through a Neutral
Safety Switch or Clutch Interlock Switch to protect the vehicle from accidently
moving during cranking of the starter. Use your vehicles existing switch or use
the circuit below to add an safety switch to your vehicle.
Start / Crank Wire from Your Key to Keyless ICm
External Automotive Relay
Start/Crank Wire from Key to Keyless ICM
Purple
PUSH BUttON SWItCH COUNSEL INStALLAtION:
The Push Button Switch can be mounted in any dash that is between 1/32”
to 1/2” in thickness. The diameter of the hole that is needed for Push Button
Switch is 7/8”. when installing the switch into the dash use the nut to fasten
it to the dash from the other end. Then by using the diagram below attach
the wires into the plug accord-
ingly and connect the plug to
the ICM box. when installing
the terminals into the connec-
tor, verify that the terminals
are facing up
(example shown
below)
. Then simply push the
wires into the connector until
you hear them click.
Diagram above shows back of plug (larger end).
This is the end to plug the terminals into.