Trim-Tex LED Light Bead - Manual

The Trim-Tex LED Light Bead is a rigid vinyl product that installs
directly to the drywall and has an angled leg that allows you to install
LED strip lighting at the optimal light angle. It accommodates low
profile
" wide LED strips. The angled leg also creates a crisp line ⅜
and accent shadow for a sharp clean look. The bead mud leg allows
the bead to seamlessly blend into your drywall. Use it in hallways,
elevator lobbies, conference rooms, decorative soffits or anywhere
you want to add LED lighting as an accent.
The optimal distance from the ceiling is 2" - 5" depending on the
LED wattage.
Installation Instructions
L.E.D. Light Bead
Please read entire instruction before proceeding.
Improper installation will void any applicable warranty.
20
Pcs Per Box
10'
Stock No. Length
LED10
LED Strip
LED Strip
LED Light Bead
Drywall
2" x 2" 2" x 2"
2" x 2" 2" x 2"
INSTALLATION: Dry fit and cut the LED Light Bead to length. The LED Light Bead has a
⅝
½ " return leg so it will not work with " Drywall. Spray the bead and drywall with Trim-
Tex 847 Spray Adhesive & immediately apply to the drywall. Once in position, press the
leg into place using the Trim-Tex installation tool or handle of your taping knife. Staple
the mud leg every 6"-8" with ½" long divergent staples. Finish the installation by mudding
and sanding the bead.
Don’t settle for a boring square soffit. Chamfer bead is just one of 11 different
ways to decorate your soffits and light coves.
Light Cove Detail
2" x 2" 2" x 2"
2" x 2" 2" x 2"
Drywall Ceiling
Soffit Detail
Single Layer
Detail
www.trim-tex.com • 3700 W. Pratt Ave. Lincolnwood, IL 60712-2508 • Phone: (847) 679-3000 • Fax: (847) 679-3017
T P E LED L B HE OSSIBILITIES ARE NDLESS WITH IGHT EAD
Chamfer Bead
350 Chamfer Bead
Chamfer Stop