Trim-Tex Mud Set Rigid Corner Bead - Manual

To boost the performance and strength of any drywall compound, use Trim-Tex's high performance MUD-MAX
drywall compound additive.
TIP
Mud Set Rigid Corner Bead &
Mud Set Rigid Jumbo
Corner Bead
METHOD 2
Trowel or box on a layer of mud/compound onto drywall corner. Place your corner bead onto the mudded corner. You can then use your
mud knife or rolling tool to press on the bead. Wipe off excess mud and finish mudding. The first coat of mud can be applied immediately. METHOD 2
SUPERIOR CORNER BEAD AT A LOWER COST, FEATURING PATENTED MUD
LOCK TECHNOLOGY WITH
MORE BONDING SURFACE.
I BEAM DESIGN IS MORE RIGID THAN STANDARD VINYL
CORNER BEAD & CREATES A SHARPER CORNER
WILL NOT OR AND ABSORBS
DOESN’T FUZZ UP DURING FINISHING & SANDING LIKE PAPER COVERED
PRODUCTS
ENGINEERED HOLE PATTERN ALLOWS EXCESS MUD TO FLOW THROUGH &
QUICKLY SELF LEVEL THE BEAD, SAVING TIME & MATERIALS
RUST PROOF RIGID VINYL BEAD, DOES NOT PROMOTE MOLD GROWTH
MUD LOCK TECHNOLOGY ASSURES NO CRACKS OR CALL BACKS
COMPATIBLE WITH MOST HOPPERS AND ROLLER TOOLS
350%
OVER 60%
DENT BLISTER EXTREME IMPACT
METHOD 1
Run your bead through a hopper to coat the under side of the bead with mud/compound. Place your bead on the corner and press down
with mud knife or rolling tool. Wipe off excess mud and finish mudding. The first coat of mud can be applied immediately. METHOD 1
INC.
I Beam creates a
more rigid bead
Patented Mud Locks
Holes allow bead to
quickly self level
MUD SET BEADS ARE DESIGNED TO BE INSTALLED WITH HIGH QUALITY DRYWALL COMPOUNDS. DO NOT INSTALL
WITH SPRAY ADHESIVES, STAPLES, NAILS OR SCREWS. DO NOT THIN OUT YOUR MUD LIKE YOU WOULD FOR PAPER
FACE BEADS. TRIM-TEX’S MICRO PERFORATION HOLE DESIGN ALLOWS THICK MUD TO DISSIPATE EVENLY. WE
RECOMMEND MIXING YOUR MUD FIRST BEFORE ADDING WATER.
Before installation, setback the drywall at least / " as shown in . If the drywall is overlapping, the bead may not be properly
aligned causing the legs to splay out as shown in . Use your blade/knife to bevel off the overlapping drywall for a flush
installation as shown in .
1 8 Figure A
Figure B
Figure C & D
Figure A Figure B Figure C Figure D
3700 W. Pratt Ave. Lincolnwood, IL 60712-2508 Phone: (847) 679-3000 Fax: (847) 679-3017
www. .com T
RIM
-T
EX
Splayed Leg
Place bead onto drywall
corner once mud is
troweled or boxed on
Use roller tool or
mud knife to press
into place
LENGTH
9'
STOCK # PCS/ BOX
M 009 SR 40
10' M 010 SR 40
8' M R008 S 40
12' M 012 SR 40
LENGTH
9'
STOCK # PCS/ BOX
M J09 SR 35
10' M J10 SR 35
8' M RJ08 S 35
12' M J12 SR 35
MUD SET RIGID JUMBO BEAD