Trim-Tex Mud Set Adjustable Beads - Manual

Mud Set Adjustable Splayed Bullnose
3700 W. Pratt Ave. Lincolnwood, IL 60712-2508 Phone: (847) 679-3000 Fax: (847) 679-3017
INC.
www. .com T RIM -T EX
Mud Set Beads are designed to be installed with All Purpose Joint Compound. Do not thin out the
mud/compound and do not install with spray adhesives, staples, nails or screws.
& Mud Set Adjustable Splayed Corner Bead
Before installing, determine your offset angle and either
close or open the bead by squeezing the corner with your
hands as shown above. Once you have formed the adjustable corner bead to your
desired angle, dry fit and adjust accordingly.
METHOD 1
Run your bead through a hopper to coat the under side of the bead with mud/compound. Place your bead on the corner and
press down with mud knife or rolling tool. Wipe off excess mud and finish mudding. The first coat of mud can be applied
immediately.
METHOD 2
Trowel or box on a layer of mud/compound onto drywall corner. Place your corner bead onto the mudded corner. You can
then use your mud knife or rolling tool to press on the bead. Wipe off excess mud and finish mudding. The first coat of mud
can be applied immediately.
Place bead onto drywall
corner once mud is
troweled or boxed on
Use roller tool or
mud knife to press
into place
To boost the performance and strength of any drywall compound, use Trim-Tex's high performance MUD-MAX drywall
compound additive.
TIP
MS7310 MSRS10
Adjustable from 125º - 145º Adjustable from 115º - 155º