Trim-Tex Niche Bead User Manual

Niche bead, Smooth transition to any corner, Please read entire instruction before proceeding

INC.

Niche Bead

Installation Instructions

3700 W. Pratt Ave. Lincolnwood, IL 60712-2508 Phone: (847) 679-3000 Fax: (847) 679-3017

www.trim-tex.com

Step 1

: Set the drywall back / " and dry fit a

small sample piece of the Niche Bead for an
accurate installation .

5 8

Step 2

: For precise miters cut a support block 1 / " x 1 / ". Always wear safety glasses when

using miter saws, staple guns, or spray adhesive. To ensure accuracy, make the miter cuts
slowly. Typically a 90º inside or outside corner will require setting the miter saw to 45º. Most
corners are rarely a true 90º so you may need to adjust the angle and make some practice
cuts first.

3 4

Step 3

: Snip back the mud legs up to the mud

bump to prevent overlapping of beads. Install
the bead with

" divergent staples every 6"

and Trim-Tex 847 Spray Adhesive. Place a
bead of adhesive caulk (Trim-Tex 710
Adhesive Caulk) at the seam and wipe away
the excess caulk.

NO ADAPTERS needed when joining an
outside or inside Trim-Tex

corner bead.

Simply snip back the mud legs and install as
previously stated.

º Outside Corner

Bead

Support
Block

45º Miter for
inside or outside
corners.

SMOOTH TRANSITION TO ANY CORNER

Splayed

Outside Corner

Bead

º Inside Corner

Bead

º Inside Corner

Bead

Splayed

Outside Corner

Bead

Adjustable In

side Corner

Bead

SHARP LOOK WITHOUT ANY ADAPTERS

64110

Please read entire instruction

before proceeding.

Improper installation will void any applicable warranty.