Trim-Tex Auto Mixer - Manual

3700 W. Pratt Ave. Lincolnwood, IL 60712-2508 Phone: (847) 679-3000 Fax: (847) 679-3017 www.trim-tex.com
To ensure a soft start on your next
bucket reduce the speed before
stopping the Auto Mixer. Unplug
the Auto Mixer and press down
on the handle to release the mixer
from the bucket.
General Warnings
DO NOT plug in mixer unless it is secured to mixing bucket.
Keep all body parts away from moving components.
Always check the handle and knob are tightly secured.
Always use auto mixer on a stable and level floor.
Installation Instructions
Auto Mixer
The Auto Mixer can be used with the supplied bucket or snapped right onto
most ready mix drywall compounds that come in standard size buckets. The
Auto Mixer can also be used for mixing color tint into exterior acrylic prod-
ucts. With the mixer unplugged, slide the paddle into the mixer and fasten
the mixer to your bucket, checking that all four hooks are securely in place. 3. Plug mixer into a GFI outlet. Push
on the trigger to start mixing slowly.
You can lock the drill in the run-
ning position by pushing button A.
To adjust mixing speed, turn dial B.
If bucket starts to shake or wobble
excessively, turn the speed down.
B
A
Once Spinning….
For ready mix compounds, add
water or Mud Max if necessary.
For acrylic products add color tint
at this time.
*The Auto Mixer should spin clockwise as shown above. If
it does not please call Trim-Tex customer support.
Copyright 2011 Trim-Tex Inc. All Rights Reserved
Please read entire instructions
before proceeding.
Improper use will void any applicable warranty.
See warranty card for details.
Don’t just thin down your
compound with water, give
it a boost with Mud-Max.
Designed to improve the
strength and adhesvie
performance of all drywall
compounds, textures and
plaster products.