Trim-Tex Decorative L Bead User Manual
Decorative l bead installation instruction, Miter support, Instrucciones para la instalacion
For Ultimate Adhesion use Trim-Tex #700/710 Adhesive Caulk!
For Ultimate Adhesion use Trim-Tex #700/710 Adhesive Caulk!
Contact us today! Phone: 800-874-2333 / Fax: 800-644-0216 / www.trim-tex.com
3
4
"R.
1
"
1
"
1
"
DECORATIVE L BEAD INSTALLATION INSTRUCTION
HOW TO INSTALL
Miter
Support
Miter
Support
Style 651 L Bead
Style 651 L Bead
INSTRUCCIONES PARA LA INSTALACION
1. Comience por cortar el esquinero 6" mas de la medida deseada. Antes de hacer los cortes, soporte la pieza para obtener
uniones mas presizas. Para el esquinero decorativo doble
, puedes utilizar dos tiras de
de tablaroca para soporte.
Pruebe las piezas y ajuste si es necesario.
2. Cuando instale sus esquinas, asegurese usar el pegamento 700/710 de Trim-Tex en la extremidad no perforada y el
pegamento 847 de Trim-Tex en la extremidad perforada. Engrape la extremidad perforada cada 6" con grapas de
x
.
Tambien se puede referir a las instrucciones del pegamento 847. No olvide agregar el pegamento 710 a las uniones y limpiar el
exceso antes de acabar.
3. Termine la instalacion con el material para tablaroca y pinte de igual manera que se recomienda a cualquier otra esquina en
paredes interiores. Para una mejor adicion del material para tablaroca a la esquina decorativa, utilize el aditivo Mud-Max de
Trim-Tex (#850/galon y #851/botella de 16 oz.)
5
5
/ "
/ "
/ "
/ "
8
8
1 2
1 2
(Spanish)
Use Trim-Tex 700/710 Adhesive Caulk
on the Return Leg
Use Trim-Tex 700/710 Adhesive Caulk
on the Return Leg
When installing your bead be sure to use
on the return leg as shown above, and
Staple the
mud leg every 6" with
T
. Don't forget
to caulk your miters and butt joints and then clean any excess
caulk before finishing.
Trim-Tex 700/710
Adhesive Caulk
on the mud leg.
/ " divergent staples. he 847 can also
has installation instructions that you can refer to
Trim-Tex 847 Spray Adhesive
1 2
Begin by roughly snipping your bead 6" longer then your
desired length. Before cutting your inside or outside corners
with a miter saw, be sure to use a support under the mud leg
for accurate miter cuts. For a double / " bead, you can use
two / " pieces of drywall for your miter support. Next, dry fit
your mitered corners and adjust as necessary.
5
5
8
8
1.
2.
Finish the installation by mudding, sanding, and painting the bead as you normally would any corner bead. To boost the
performance and strength of your drywall compound, use Trim-Tex's high performance MUD-MAX drywall compound
additive (stock # 850 for Gallon & 851 for 16 oz Bottle).
3.
© Copyright 2007 Trim-Tex Inc. All Rights Reserved